Home // Automotive // Dodge
INSTALLATION INSTRUCTIONS Model: 7010, 7010TK, 7020, 7020TK DODGE ...
Source: www.powervisionmirrors.com
File Size: 621.7 KB
Category: Automotive
Last Download : 34 days 22 hours 59 minutes ago
Short Description: Dodge (7010, 7010TK, 7020, 7020TK) Installation. Page 3. 2. After the mirrors have been mounted, plug the Power Vision male connector into the ...
Content Inside: INSTALLATION INSTRUCTIONS Model: 7010, 7010TK, 7020, 7020TK DODGE RAM 1500 94-01, Dodge Ram 2500 & 3500 94-02 with stock power mirrors. YOU MUST HAVE POWER MIRRORS ...IF YOU DO NOT CURRENTLY HAVE POWER MIRRORS, THE WRONG SET HAS BEEN ORDERED. Caution! - Do not attempt to manually extend or retract the mirrors. They should be moved under their own motor power only. Tools required for the installation are: 10mm socket, a 10mm open end wrench, trim panel remover, philips screwdriver, razor knife, and an inch pound torque wrench. Models 7010TK and 7020TK will require a volt meter. Extra door trim panel clips may be necessary. If you have any questions after reading this installation manual, please call our service department at (800) 337-2557. REMOVAL OF EXISTING MIRRORS 1. Have both windows in the down position. Remove the trim panel on both doors. 2. Unplug the electric cord that comes from the mirrors located on each door. 3. Remove the foam insulation covering the stock mirror mounting nuts. 4. Support the stock mirror while removing the 3 mirror mount lug nuts. 5. Remove the stock mirror. MOUNTING POWER VISION MIRRORS: 1. To assemble the mount assembly, first insert the studs and then line up the mount with the gasket. Apply the mount on the door, while supporting the mirror add the washers and nuts to the studs on the outer door skin (This will allow you to squeeze up the gasket and make it easier to start the bolt). Next slide on the support plate and insert the bolt with a washer and the remaining two washers and nuts onto the studs and tighten down to 70 torque inches. There must be adequate foam around the front and bottom edges to prevent the mount from making direct contact with the painted door. This foam is necessary for sealing against moisture and wind noise. Use the same procedure on the passenger side door.
Related PDF Files
Related Search:
